Why decking oil

Douglas Fir: 6 weeks exposure. Application of WR Base Coat is also recommended. Larch: 6 weeks exposure. Decking-Oil Larch is optically suitable. Application of WR Base Coat is recommended before use. Cedar: 12 weeks exposure. Iroko: 12 weeks exposure. Mahogany: 12 weeks exposure. Teak: 12 weeks exposure. Tropical Walnut: weeks exposure.

Merbau: 12 weeks exposure. Ipe: weeks exposure. Pressure-Impregnated Pine: 12 weeks exposure. Garapa: 12 weeks exposure. Balau: 12 weeks exposure. Bangkirai: 12 weeks exposure. Massaranduba: 12 weeks exposure. Idigbo: contains yellow dyes which leaches when the wood becomes wet and stains when in contact within iron. Other: woods treated with a varnish, lacquer or other surface coatings must be completely sanded before use.

Top Tips. Top Tips: For a clear and natural finish for decking, apply just two coats of Teak Oil, which allows the wood to naturally grey over time.

The darker the colour, the slower the greying process of the wood will start to appear. Osmo Anti-Slip Decking Oil can be used as the second coat after any of the coloured Decking Oils to provide a slip resistant surface. Additional Information: Approx. Also Recommended. Use our Decking Cleaner to do this. Even if your decking is new, sometimes the wood is treated with chemicals that may prevent the Clear Decking Oil from soaking in properly.

Thorough cleaning will make for a more even application of Decking Oil and for a nicer end finish. If your decking is badly weathered, the Decking Cleaner will remove all the dirt, grime and any green staining; greatly improving the look before applying the oil.

If your decking has been stained make sure to remove all loose, flaking and peeling finish first. Often a good scrub with a Scrubbing Brush will be enough to do this. Pour the Clear Decking Oil into a tray to make application easier. It can be applied with a foam pad or brush. Dip the applicator into the oil and you start oiling the decking. Going in the direction of the grain, apply the Decking Oil quite liberally and work it into the wood. You'll instantly see the oil being absorbed; bringing out the natural beauty in the wood.

Leave the oil for five minutes to penetrate. Whatever you happen to be doing, there are some tips and tricks that always hold true for best results:. Why not stop by your local, take a browse and see how we can help get your decking shipshape in time for summer?

View All News. You are here: Home News. First off… What are oils and stains? Decking oils A protective, practical measure mainly designed to preserve the wood while helping to replace the natural oils of the timber, which fade over time. Decking stains Decking stains are designed first and foremost to change the colour of the decking boards, enhancing the appearance of the timber by highlighting the natural grain. Calculator Submission.

Use for the following wood types. How to use Nourishing Decking Oil. Number of coats 2 coats. Coverage Up to 10m2 per litre. Application Brush or decking pad. How to oil your deck Before you start. How to prepare new decking for oiling Most new decks come with a bit of waterproofing protection. This could stop the oil from sticking. Alternatively, leave it to weather for six months. Rinse thoroughly with water, ideally with a pressure washer.

To check if any pre-treatment is remaining, sprinkle some water on the deck and see if it beads. If it doesn't bead, you'll be ready to put on the oil. If it does then you'll have to clean it again until the water stops beading.